Power Supply
 
 

I/O Board
(8-1/2" x 4-1/2")
[1]

Audio Amp
(?" x ?")
[2]

Mother / Sounds
(19-1/4" x 10")
[3]

EPROM Board
(12-1/4" x 6")
[4]

Rotate Video PCB
(20" x 11")
[5]

Line Drawer PCB
(20" x 10")
[6]

Fill PCB
(20-1/2" x 9-7/8")
[7]

Instruction
Sheet
(8-1/2" x 14")
[8]

Full Cage
 (front left view) 
 
 

Full Cage
 (back left view) 
 
 

Operation and
Service Manual
 
 


[1]  Mounted on the back outside of the cage.
[2]  Mounted on the left outside of the cage.
[3]  This is the first of four boards (from the left) in the slots inside the cage.
The battery is to be installed on this board, just to the right of the middle,
at the top, where the word "battery" is printed.
[4]  This board is mounted on top of the Mother/Sounds board as a satellite/daughter board.
So, this is actually the farthest board on the left inside the cage.  However, it does not have
any rail slots of its own in the cage.
[5]  This is the second of four boards (from the left) in the slots inside the cage.
[6]  This is the third of four boards (from the left) in the slots inside the cage.
[7]  This is the fourth of four boards (from the left) in the slots inside the cage.
[8]  This sheet is taped on the inside of the cage door.  (You can see tape marks on the door
in the picture.)  There is another sheet taped to the outside/front of the door, but there is
currently no picture of it.

 

 

Marquee

Monitor Bezel
Control Panel

 

 

Laserdisc
(single-sided, plastic)
(side 1)

Laserdisc
(single-sided, plastic)
(side 2)

Magnavox VC8010
(21" x 15-3/4" 29.8 lbs)

Manufacturer:
Simutrek (USA, 1983)

Emulation and Ports
Tech Center
Game Info

Message Board
Locations
Chat Room

 


QUESTIONS? COMMENTS? PROBLEMS?
Contact Us

HOME | LASER GAMES | LASER COMMUNITY | TECH CENTER

This website was created by Jeff Kinder & Dave Hallock, 1997 - 2021.
All trademarks and copyrighted materials are property of their respective owners.